Repara tus cosas Comunidad Tienda

Cambios al paso #1

Editado por Justin Ogihara —

Edicion aprobada por Justin Ogihara

Antes
Después
Sin cambios

Líneas de Paso

[title] Remove fan
-[* red] Once the back panel is removed, remove the highlighted screws (M2x3.2mm) and set them aside.
-[* orange] Next remove the power supply chord that is going into the motherboard. The colors of the wires should be: red, yellow, brown and black.
-[* black] If the fan does not pop out then all you need to do is use the knife tool and pop it out slightly from the flat edge of the fan.
-[* black] In order to replace the fan you must plug the power supply back into the motherboard and then screw the fan back into the laptop
+[* red] Once the back panel is removed, remove the two 3.2mm screws using the Phillips #00 screwdriver.
+[* orange] Remove the power supply cord that is going into the motherboard. The colors of the wires should be: red, yellow, brown and black.
+[* black] Remove the fan from the device.
+[* icon_note] If the fan does not pop out then all you need to do is use the knife tool and pop it out slightly from the flat edge of the fan.