Saltar al contenido principal

Cambios a Paso #1

Editado por Debra Crawford

Edicion aprobada por Debra Crawford

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Place the drone on its back, with the runners facing upward.
[* black] Using the Phillips screwdriver, unscrew the single 2mm screw located on the drone body which connects the headlamp and wiring to the center of the drone frame.
[* black] Grasp one of the propeller arms with the fingers of one hand while holding the drone frame with the other hand. .
[* black] Next, pull the propeller arm upward to separate it from the drone body. Repeat this process to remove the three other propeller arms.
[* black] Carefully remove the drone body from the frame.
[* black] Using your fingers, unfastenFlip the tape holdingbody onto the wiring insiderunners so the central chassis of the dronewires are facing upward.
[* black] Using your fingers, unfastenFlip the tape holdingbody onto the wiring insiderunners so the central chassis of the dronewires are facing upward.