Saltar al contenido principal

Cambios a Paso #1

Editado por Debra Crawford

Edicion aprobada por Debra Crawford

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Place the drone on its back, with the runners facing upward.
[* black] Using the Phillips screwdriver, unscrew the single 2mm screwsscrew located on the drone body which connects the headlamp and wiring to the center of the drone.
[* black] Using the Phillips screwdriver, unscrew the single 2mm screwsscrew located on the drone body which connects the headlamp and wiring to the center of the drone.
[* black] Carefully remove the central component of the drone from the drone body.
[* black] Using your fingers, unfasten the tape holding the wiring inside the central chassis of the drone.