Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Cambios al paso #5

Editado por Nicholas Allen

Edicion aprobada por Nicholas Allen

Antes
Después
Sin cambios

Líneas de Paso

[* red] Flipblack] Flip the drone on its back
[* orangered] Remove the eight 4.5mm hex screws with a 1.5mm hex bit.
[* yellowblack] Separate the mesh from the drone by pulling up gently and rocking left to right.
[* red] Flipblack] Flip the drone on its back
[* orangered] Remove the eight 4.5mm hex screws with a 1.5mm hex bit.
[* yellowblack] Separate the mesh from the drone by pulling up gently and rocking left to right.
[* icon_caution] The cable connects from the camera to the drone. Pulling up could rip the connection. Tilt the mesh 90 degrees towards the cable.

Imagen 1

Versión Antigua

Nueva Versión

Imagen 2

Versión Antigua

Nueva Versión