Saltar al contenido principal

Repara tus cosas

Derecho a reparar


Cambios al paso #4

Editado por Noah

Edicion aprobada por Noah

Sin cambios

Líneas de Paso

[* black] Align the breaker plate with the distributor body and screw it into place.
[* black] Attach the other side of the grounding strap to the breaker plate hold-down screw as shown.
[* black] Slide the magnetic sleeve onto the distributor shaft. Make sure that it is pressed firmly in place.
[* black] Using the provided plastic feeler gauge, or a 0.030" feeler gauge, set the gap between the ignition unit and the magnetic sleeve.
[* black] While holding the ignition unit in place tighten the two locking nuts.

Imagen 1

Ninguna imagen anterior


Imagen 2

Ninguna imagen anterior