Saltar al contenido principal

Cambios a Paso #3

Editado por Noah

Edicion aprobada por Noah

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Your distributor should now look the same as the one pictured to the left.
[* black] Take note of the notch on the body of the distributor opposite the vacuum advance can: this is where the new leads exit.
[* black] Place the new breaker plate back on the distributor, so that the threads face up, and the advance pin slides into the vacuum advance shaft.
[* black] Place the ignition module on the threaded studs as shown.
[* black] Set one end of the ground strap on the stud nearest to the notch and loosely put on the two locking nuts.
[* black] Take note of the notch on the body of the distributor opposite the vacuum advance can: this is where the new leads exit.
[* black] Place the new breaker plate back on the distributor, so that the threads face up, and the advance pin slides into the vacuum advance shaft.
[* black] Place the ignition module on the threaded studs as shown.
[* black] Set one end of the ground strap on the stud nearest to the notch and loosely put on the two locking nuts.

Imagen 2

Ninguna imagen anterior

Añadido