Saltar al contenido principal

Changes to Step #12

Editado por Andrew Bookholt

Aprobación pendiente

Borrada
Añadida
Sin cambios

Step Lines

[* black] If necessary, use a spudger to pry up the left edge of the logic board to separate the solidified thermal paste from the heat sink.
[* icon_note] If any resistance is felt when prying up on the logic board, we recommend softening the thermal paste by heating the board with a blowhair dryer or a heat gun before prying further.
[* icon_note] If any resistance is felt when prying up on the logic board, we recommend softening the thermal paste by heating the board with a blowhair dryer or a heat gun before prying further.