Saltar al contenido principal

Changes to Step #12

Editado por Walter Galan

Aprobación pendiente

Borrada
Añadida
Sin cambios

Step Lines

[* black] If necessary, use a spudger to pry up the left edge of the logic board to separate the solidified thermal paste from the heat sink.
[* icon_note] If you need to mountany resistance is felt when prying up on the logic board back into the laptop, we have a [guide|744|thermal paste guide] that makes replacingboard, recommend softening the thermal compound easypaste with a blow dryer or a heat gun before prying further.
[* icon_note] If you need to mountany resistance is felt when prying up on the logic board back into the laptop, we have a [guide|744|thermal paste guide] that makes replacingboard, recommend softening the thermal compound easypaste with a blow dryer or a heat gun before prying further.