Saltar al contenido principal

Cambios al paso #11

Editado por plomero20

Edicion rechazada por Mariana

Antes
Después
Sin cambios

Líneas de Paso

+[* icon_reminder] If your replacement part does not come with a plastic barometric vent, transfer the one from your old part to the new one.
+ [* black] Use the edge of an opening tool to gently push up and loosen the barometric vent from the board.
+ [* icon_note] Be careful not to push too hard, or you will bend the vent's plastic alignment pins.
+ [* red] You may need to use some adhesive or double-sided tape in order to attach the vent to the new part. If you do, be sure not to cover the bottom vent hole.