Saltar al contenido principal

Cambios al paso #3

Editado por Ryan Wheeler

Edicion aprobada por Ryan Wheeler

Antes
Después
Sin cambios

Líneas de Paso

[* red] Using the Philips head #1 screwdriver, remove the ten screws from the back panel. Two top corner screws (12cm), two battery screws (15cm), and six case screws (10cm).
[* icon_reminder] Note which screws go where. The two largest (15cm) are on top of the battery, the next two largest (12cm) go in the upper corners (close to the hinge) while the smaller ones (10cm) make up the rest of the case.
[* icon_reminder] Note which screws go where. The two largest (15cm) are on top of the battery, the next two largest (12cm) go in the upper corners (close to the hinge) while the smaller ones (10cm) make up the rest of the case.