Saltar al contenido principal

Cambios al paso #3

Editado por Taylor Peters

Edicion aprobada por Taylor Peters

Antes
Después
Sin cambios

Líneas de Paso

[* redblack] Using the Philips head #1 screwdriver54 bit driver with PH0 screw driver head, remove the ten screws from the back panel. Two Two battery screws (15.6 mm), two top corner screws (12cm), two battery screws (15cm12.5 mm), and six case screws (10cm9.7 mm).
[* icon_reminder] Note which screws go where. The two largest (15cm)battery screws are oncircled in red. The top of the battery, the next two largest (12cm) gocorner screws are circled in the upper corners (close to the hinge) while the smaller ones (10cm) make up the rest of the caseorange. The remaining case screws are circled in yellow.
[* redblack] Using the Philips head #1 screwdriver54 bit driver with PH0 screw driver head, remove the ten screws from the back panel. Two Two battery screws (15.6 mm), two top corner screws (12cm), two battery screws (15cm12.5 mm), and six case screws (10cm9.7 mm).
[* icon_reminder] Note which screws go where. The two largest (15cm)battery screws are oncircled in red. The top of the battery, the next two largest (12cm) gocorner screws are circled in the upper corners (close to the hinge) while the smaller ones (10cm) make up the rest of the caseorange. The remaining case screws are circled in yellow.

Imagen 1

Versión Antigua

Nueva Versión