Saltar al contenido principal

Cambios al paso #1

Editado por Arthur Shi

Edicion aprobada por Arthur Shi

Antes
Después
Sin cambios

Líneas de Paso

-[* black] Use an [product|IF145-198-8|iOpener] or heat gun to gently heat the outer edges of the screen.
- [* icon_note] The surfaces near the speaker and microphone (top and bottom respectively) have larger adhesive sections. These areas may require slightly longer heat exposure. Heat will help soften the adhesive securing the display, making it easier to separate. The display should be heated until it's slightly too hot to touch, for roughly two minutes.
+[* black] [guide|25705|Heat an iOpener|new_window=true] and apply it to the left edge of the display for two minutes.
+ [* icon_caution] A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the display and internal battery are both susceptible to heat damage.
+[* black] Take note of the adhesive regions before you begin prying:
+ [* red] Thin adhesive lined against the display panel
+ [* orange] Thick adhesive

Imagen 1

Versión Antigua

Nueva Versión

Imagen 2

Ninguna imagen anterior

Añadido