Saltar al contenido principal

Cambios a este Paso

Editado por Paul Peavyhouse

Edicion aprobada por Taylor Dixon

Antes
Después
Sin cambios

Líneas de Paso

[* black] Slide the pick around the corner and continue to cut through the adhesive.
- [* icon_note] You can cut deeper into the top and bottom bezel areas, as long as the pick does not reach the display panel.
+ [* icon_caution] You can cut a bit deeper into the top and bottom bezel areas, but not too much more (do NOT use the bezel color as guide). The digitizer circuitry is adhesed to part of the lower bezel and should remain so; it is very fragile and should not be cut in to (the top is fairly safe). Use the images in Step 7 as a guide.
[* black] Leave an opening pick on each side as you continue to the next to prevent the adhesive from resealing.
[* black] Repeat the process until you have sliced around the entire perimeter.
[* icon_caution] Be careful not to insert the pick more than 1.5 mm along the long edges, or you will damage the display assembly.