Saltar al contenido principal

Cambios a este Paso

Editado por Adam O'Camb

Edicion aprobada por Adam O'Camb

Antes
Después
Sin cambios

Líneas de Paso

[* icon_caution] This connector is seated deeply in the frame, so be careful not to damage the connector when performing this step.
[* black] Put the flat end of a [product|IF145-002-2|spudger] under the lip of the press fit connector and lift up to pop the connector free.
[* black] Remove the [product|IF356-001|LCD screen and digitizer].
-[* icon_reminder] Gently scrape the remaining screen adhesive from your phone. Use gentle heat and a small amount of isopropyl to clean the frame and prep it for the new screen adhesive.
+[* icon_reminder] Gently scrape any remaining adhesive from your phone. Use a small amount of high concentration isopropyl alcohol (at least 90%) to clean the frame and prep it for the new screen adhesive.
+[* icon_reminder] The replacement adhesive should only be applied to the edges of the frame, but may come with the center filled in.
+ [* black] To remove the unnecessary center section of the adhesive strip, carefully peel away the perforated rectangle in middle of the white backing. At the same time, peel up the black adhesive underneath the white backing.
+ [* icon_note] Only adhesive for the edges of the frame should remain.