Saltar al contenido principal

Cambios a este Paso

Editado por Arthur Shi

Edicion aprobada por Arthur Shi

Antes
Después
Sin cambios

Líneas de Paso

-[* icon_caution] This connector is seated deeply in the frame, so be careful not to damage the connector when performing this step.
-[* black] Put the flat end of a [product|IF145-002-2|spudger] under the lip of the press fit connector and lift up to pop the connector free.
- [* black] Remove the [product|IF356-001|LCD screen and digitizer].
-[* icon_reminder] Gently scrape any remaining adhesive from your phone. Use a small amount of high concentration isopropyl alcohol (at least 90%) to clean the frame and prep it for the new screen adhesive.
-[* icon_reminder] The replacement adhesive should only be applied to the edges of the frame, but may come with the center filled in.
- [* black] To remove the unnecessary center section of the adhesive strip, carefully peel away the perforated rectangle in middle of the white backing. At the same time, peel up the black adhesive underneath the white backing.
- [* icon_note] Only adhesive for the edges of the frame should remain.
+[* black] Slide the pick around the corner and continue to cut through the adhesive.
+[* black] Leave an opening pick on each side as you continue to the next to prevent the adhesive from resealing.
+[* black] Repeat the process until you have sliced around the entire perimeter.
+[* icon_caution] Be careful not to insert the pick more than 1.5 mm along the long edges, or you will damage the display assembly.

Imagen 1

Versión Antigua

Nueva Versión

Imagen 2

Versión Antigua

Nueva Versión