Saltar al contenido principal

Cambios a Repairing Kenmore Elite HE3 Washer Control Board Relays Introducción

Editado por jadeters

Aprobación pendiente

Antes
Después
Sin cambios
Dispositivo
Kenmore Elite HE3 Washer
Type
repair
Thing
Control Board Relays
Title
Repairing Kenmore Elite HE3 Washer Control Board Relays
Introduction
The Kenmore Elite HE3 washers will stop their cycle and display an error code if they detect a problem. Two error codes seem prevalent, FDL and F11. FDL indicates a failure of the door lock mechanism. F11 indicates an error in communication with the control board and the front panel. Clearing the error and restarting the cycle may fix the problem temporarily, but is not a permanent fix.
One problem known to cause the problem is that the door latch relay on the control board can become coated with carbon due to excessive arcing. This guide will explain how to access and clean or replace the relays.
Time Required Min
1 hora
Time Required Max
2 horas
Difficulty
Difficult
Conclusion
To reassemble your device, follow these instructions in reverse order.
Author
Public
No
Summary
Cleaning the contacts on the control board relays can fix the FDL and F11 errors.

Herramientas

  • 6-in-1 Screwdriver x1 added.
  • Desoldering Braid x1 added.
  • Lead-Free Solder x1 added.
  • Soldering Workstation x1 added.
  • TR10 Torx Security Screwdriver x1 added.

Banderas

  • In Progress added.
  • Member-Contributed Guide added.

Pasos

Step #: 1
Antes
Después
Step #: 2
Antes
Después
Step #: 3
Antes
Después
Step #: 4
Antes
Después
Step #: 5
Antes
Después