Historial de introducción: TicWatch E3 Motherboard Replacement

Dispositivo	TicWatch E3
Type	replacement
Thing	Motherboard
Title	TicWatch E3 Motherboard Replacement
Introduction	Use this guide to replace the motherboard in your TicWatch Pro 3 GPS. You’ll need replacement adhesive when reassembling the device. Your device will function normally, but will most likely lose its IP (Ingress Protection) rating.
Time Required Min	20 minuto
Time Required Max	40 minuto
Imageid	Antes Después
Difficulty	Moderate
Conclusion	Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before you install it. ***To reassemble your device, follow these instructions in reverse order.*** During reassembly, apply new adhesive where it's necessary after cleaning the relevant areas with isopropyl alcohol (>90%). For optimal performance, [[Battery Calibration|calibrate your newly installed battery|new_window=true]] after completing this guide. Take your e-waste to an [[E-Waste|R2 or e-Stewards certified recycler|new_window=true]]. Repair didn’t go as planned? Try some [[Troubleshooting Problems After a Repair|basic troubleshooting]], or ask our [link|https://www.ifixit.com/Answers/Ask/TicWatch+E3|TicWatch E3 answers community] for help.
Author	Dominik Schnabelrauch
Public	No

Prerrequisitos de Guía

• #1 era empty pero ahora es Opening Procedure.

Herramientas

Marcadores

Pasos

Paso #: 1

Antes

Después