Saltar al contenido principal

Cambios a iPad 2 GSM Front Panel Adhesive Strips Replacement Introducción

Editado por Andrew Optimus Goldheart

Edicion aprobada por Andrew Optimus Goldheart

Antes
Después
Sin cambios
Introduction
Replace the adhesive securing the front panel to the rear case of your iPad 2 GSM.
Before you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off.
Throughout this procedure, it is recommended to peel up each adhesive strip as needed.