Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip Bob over and remove the 7 screws around which hold the cover together.
-
Remove the main brush. Unscrew the holder, and lift the brush out. Reminder: Keep this screw separate from the others so you can use it later to reinstall.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
There are two screw holes inside the brush compartment: one in the centre, one on the left end. Remove both and keep aside for reassembly.
-
There are five more screws around bObsweep's edges. Two are installed at the top and bottom, and one on the right end of the main brush.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip bOb back over so you can see the screen. Lift the cover up to reveal bObsweep’s main board.
-
Detach the power inlet from the cover. Grip and slide it out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove three circuit plugs from the motherboard. Pinch the small white tab on the side of each circuit plug and pull straight up to release each from the motherboard.
-
1. On the bottom left corner: a small connector with red, black and white wires.
-
2. One thick white wire that attaches on the right side of the previous connector.
-
3. On the top edge of bOb’s motherboard: a wide multicoloured connector.
-
Place the cover aside and begin your repair.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four screws holding the screen in place
-
Lift the screen up and it will detach from the cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The screen and cover buttons will lift out together, leaving an open space for your replacement parts to fit into.
-
If you remove the infrared sensor, replace it in its space on the new cover so the black side will be on bOb’s outside.
-
Then, install all four screws for the LCD display. To finish off the repair, simply follow: Closing bObsweep's cover after repair
-
