Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two screws from the bottom of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the device over and remove the four screws bordering the grate of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
On the front of the device, slide the battery compartment cover off by pushing inward and sliding downward.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two screws from the lip of the battery compartment.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the final screw from the bed of the battery compartment.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Run the pry tool along the edges of the device to begin separating the device in two halves.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Apply upward pressure to fully separate the device into two halves.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift display screen keeping the top half close to the board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently flip the black clip up attaching the ribbon of the screen to the circuit board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently slide the ribbon from the circuit board, removing the screen.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.
3 comentarios
My zoom q3HD only have the red light turned on when powering up. No display at all. What is happening? How can I claim warranty? I didn't use the device more than a year. Help me
Yes it would be good to see it finished. I am half way through taking mine apart to clean the lens amd i don't know if i should proceed or not. Its the 2nd time the lens has fogged up. My 2nd q3hd.