Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Zeepad 7.0 Screen Replacement

Qué necesitas

  1. Zeepad 7.0 Screen Replacement, Screen: paso 1, imagen 1 de 2 Zeepad 7.0 Screen Replacement, Screen: paso 1, imagen 2 de 2
    • Power off the device and keep it unplugged.

    • Open the case using a plastic opening tool around the edges. Slightly pull the cover off.

    • Do not completely remove back casing because there is a speaker attached to the back.

  2. Zeepad 7.0 Screen Replacement: paso 2, imagen 1 de 1
    • Using the Phillips Head 0 bit, carefully unscrew the three 3.5mm screws holding the motherboard in place on to the back of the screen.

  3. Zeepad 7.0 Screen Replacement: paso 3, imagen 1 de 2 Zeepad 7.0 Screen Replacement: paso 3, imagen 2 de 2
    • Disconnect the two ribbon cables between the screen and the motherboard.

    • Be careful not to rip out the ribbon cables or you can harm the ports.

  4. Zeepad 7.0 Screen Replacement: paso 4, imagen 1 de 1
    • Cut the power cables connecting between the screen and the motherboard. There should be a red and black cable each.

  5. Zeepad 7.0 Screen Replacement: paso 5, imagen 1 de 2 Zeepad 7.0 Screen Replacement: paso 5, imagen 2 de 2
    • Separate the front screen protector from the lcd screen. There are clamps holding the screen in place.

  6. Zeepad 7.0 Screen Replacement: paso 6, imagen 1 de 3 Zeepad 7.0 Screen Replacement: paso 6, imagen 2 de 3 Zeepad 7.0 Screen Replacement: paso 6, imagen 3 de 3
    • Separate the LCD screen from the metal protecting case with the metal spudger.

  7. Zeepad 7.0 Screen Replacement: paso 7, imagen 1 de 3 Zeepad 7.0 Screen Replacement: paso 7, imagen 2 de 3 Zeepad 7.0 Screen Replacement: paso 7, imagen 3 de 3
    • After creating space to work, warm up a soldering iron.

    • Apply heat onto the solder over the corresponding cut wires to the new screen wires.

    • Cómo soldar y desoldar conexiones

    • The soldering iron will be extremely hot. Keep out of direct contact to other wires, the motherboard, and especially the battery.

    • Keep out of reach of children.

Conclusión

To reassemble your device, follow these instructions in order.

Una persona más ha completado esta guía.

Harry Winter

Miembro Desde 03/26/18

157 Reputación

1 Guía escrita

Equipo

IUPUI, Team S2-G1, Harley Spring 2018 Miembro de IUPUI, Team S2-G1, Harley Spring 2018

IUPUI-HARLEY-S18S2G1

3 Miembros

4 Guías creadas

2 comentarios

where do you buy the screen?

Zuzzi Z Amend - Contestar

i need a battery an a screen? is their a place on this page where to get them?

Zuzzi Z Amend - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 5

Todo El Tiempo: 460