Saltar al contenido principal

Introducción

How to remove the screen for the ZTE ZMAX Z970. Removing the screen is easiest with an iOpener which requires a microwave.

  1. Insert a fine point tool into the hole on the top left side of the phone to remove the SIM and SD card trays. Pull out the trays.
    • Insert a fine point tool into the hole on the top left side of the phone to remove the SIM and SD card trays.

    • Pull out the trays.

  2. Insert a plastic opening tool into the groove between the phone’s back cover and casing. Move the plastic opening tool along the edges of the phone to unclip the two pieces.
    • Insert a plastic opening tool into the groove between the phone’s back cover and casing.

    • Move the plastic opening tool along the edges of the phone to unclip the two pieces.

  3. Remove the ten 1.2mm screws with a Phillips #000 screwdriver. Remove the ten 1.2mm screws with a Phillips #000 screwdriver. Remove the ten 1.2mm screws with a Phillips #000 screwdriver.
    • Remove the ten 1.2mm screws with a Phillips #000 screwdriver.

  4. Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now

    Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now
  5. Remove the mid frame with the plastic opening tool. Remove the mid frame with the plastic opening tool.
    • Remove the mid frame with the plastic opening tool.

  6. Disconnect the battery from the motherboard. Disconnect the battery from the motherboard.
    • Disconnect the battery from the motherboard.

  7. Wedge a spudger underneath the battery and gently pry upwards to remove the battery. Once free from the glue, remove from device.
    • Wedge a spudger underneath the battery and gently pry upwards to remove the battery.

    • Once free from the glue, remove from device.

    • The glue holding down the battery is strong so work slow and cautiously to avoid starting a fire.

  8. Heat up the iOpener for 30 seconds and place on top of the phone for 2 minutes.
    • Heat up the iOpener for 30 seconds and place on top of the phone for 2 minutes.

  9. Wedge the opening picks into all the corners of the phone and lift until the screen comes off.
    • Wedge the opening picks into all the corners of the phone and lift until the screen comes off.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Ismail Jhaveri

Miembro Desde 15/02/18

159 Reputación

1 Guía escrita

Equipo

USF Tampa, Team S17-G3, Boczar Spring 2018 Miembro de USF Tampa, Team S17-G3, Boczar Spring 2018

USFT-BOCZAR-S18S17G3

3 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 7

Últimos 30 Días: 27

Todo El Tiempo: 567