Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Before you begin start by putting on a ESD wrist strap to prevent ESD damage and remove the battery.
-
Flip over the drone so that the propellers are facing down and the camera is facing up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grip the cover that covers the rest of the wires, and give it a slight pull to remove it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 4 rubber plugs that hold the drone and its internal parts together.
-
These plugs can be located in each corner of the drone, and are white.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unplug the four cables that are connected on the top face of the frame.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The rest of the wires that are still connected can be unplugged.
-
Using a pair of tweezers they can be unplugged.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift up or tilt entire frame and mother board and unplug all the wires.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The battery connector has two wires connected to a plug in with two little screws.
-
Unscrew the two screws and pull it apart using a small tweezers.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip over the frame and mother board and unscrew the mother board.
-
There are four screws on each corner of the mother board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After the screws are out, the motherboard can be pulled out softly with hands.
-
Remove the motherboard from the device.
-
Cancelar: No complete esta guía.
5 personas más completaron esta guía.