Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Partes y herramientas

Introducción

Batteries are meant for reuse, but if they don't recharge then they may need to be replaced. This guide will show you how to safely remove your mobile device's battery.

  1. Check to make sure that the device is powered off. Use a pin or paper clip to insert in the hole on the side of the phone next to the micro SIM cardholder to remove the tray. Remove the SIM card tray from the Xiaomi Mi 4 and store it somewhere safe.
    • Check to make sure that the device is powered off.

    • Use a pin or paper clip to insert in the hole on the side of the phone next to the micro SIM cardholder to remove the tray.

    • Remove the SIM card tray from the Xiaomi Mi 4 and store it somewhere safe.

  2. Using the flat metal spudger and curved metal spudger, make a wedge between the plastic back cover and the inner frame Using the second spudger, slowly work your way around the perimeter of the device Listen for clicking sounds as you are prying the back cover away from the frame
    • Using the flat metal spudger and curved metal spudger, make a wedge between the plastic back cover and the inner frame

    • Using the second spudger, slowly work your way around the perimeter of the device

    • Listen for clicking sounds as you are prying the back cover away from the frame

    • As the back cover is almost completely removed, use the suction-cup tool to remove the plastic cover without damaging the back

  3. Kit de Destornilladores Manta

    112 bits for every fix.

    Upgrade Your Toolbox

    Kit de Destornilladores Manta

    Upgrade Your Toolbox
  4. Use a 000 phillips head screwdriver to remove the 10 1.2mm phillips head screws in the plastic frame that hold the motherboard and battery. Use a 000 phillips head screwdriver to remove the 3 0.5mm phillips head screws in the plastic frame that hold the motherboard and battery. Use the small plastic opening tool and place it in the slot on the bottom right corner of the inner frame and carefully pry it off.
    • Use a 000 phillips head screwdriver to remove the 10 1.2mm phillips head screws in the plastic frame that hold the motherboard and battery.

    • Use a 000 phillips head screwdriver to remove the 3 0.5mm phillips head screws in the plastic frame that hold the motherboard and battery.

    • Use the small plastic opening tool and place it in the slot on the bottom right corner of the inner frame and carefully pry it off.

  5. Use tweezers to gently disconnect the connections that run across the battery and are connected to the motherboard. Proceed to gently remove the tape like connector from the battery until it is completely off. Use tweezer to disconnect battery’s wire from the motherboard.
    • Use tweezers to gently disconnect the connections that run across the battery and are connected to the motherboard.

    • Proceed to gently remove the tape like connector from the battery until it is completely off.

    • Use tweezer to disconnect battery’s wire from the motherboard.

  6. Use the plastic opening tool to gently pry the battery out of its casing for removal. Use the plastic opening tool to gently pry the battery out of its casing for removal.
    • Use the plastic opening tool to gently pry the battery out of its casing for removal.

Conclusión

To reassemble your device, follow these instructions in reverse order.

45 personas más completaron esta guía.

Equipo

USF Tampa, Team 15-6, Blackwell Fall 2015 Miembro de USF Tampa, Team 15-6, Blackwell Fall 2015

USFT-BLACKWELL-F15S15G6

2 Miembros

10 Guías creadas

Sir, I accidentally put a hole in battery while removing. Will this create a problem/explosion..

Apawilo Zawk - Contestar

Hey Apawilo. A punctured battery has potential to be very dangerous (Fire, harmful chemicals, etc), so please make sure to dispose of it at the nearest e-waste recycling site.

Geoff Wacker -

sir i am charging my phone but its percentage is not increasing ....this is a battery problem

adishsaggar123 - Contestar

im having the similar problem, when charging power increase slower and the consumption is faster than usual. please advice. thanks

Zeff Soo -

Hi..my xiaomi 4 cant be started.. after fully charged, it went blank n cant be restarted.. few days back, it was on n of for multiple time for several minutes...

Ezrat sam - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 107

Ultimos 30 días: 1,108

Todo El Tiempo: 130,700