Saltar al contenido principal
  1. Este paso está sin traducir. Ayuda a traducirlo

    Remove the battery cover.
    • Remove the battery cover.

    • Remove batteries.

  2. Este paso está sin traducir. Ayuda a traducirlo

    Grip the controller firmly to remove the side handle cover. Use a flathead screwdriver or a spudger to wedge between the seams of the front to the side handle of the controller. Move the flathead screwdriver all the way around the side plates seam and push the plate forward.
    • Grip the controller firmly to remove the side handle cover.

    • Use a flathead screwdriver or a spudger to wedge between the seams of the front to the side handle of the controller.

    • Move the flathead screwdriver all the way around the side plates seam and push the plate forward.

  3. Este paso está sin traducir. Ayuda a traducirlo

    Use a screwdriver and punch a hole directly in the center label. There you will find a hidden screw. Remove the five 10mm screws located on the back of the controller using a T8 screwdriver.
    • Use a screwdriver and punch a hole directly in the center label. There you will find a hidden screw.

    • Remove the five 10mm screws located on the back of the controller using a T8 screwdriver.

  4. Este paso está sin traducir. Ayuda a traducirlo

    Remove the backplate. Remove the backplate.
    • Remove the backplate.

  5. Este paso está sin traducir. Ayuda a traducirlo

    Remove the faceplate. Remove the faceplate.
    • Remove the faceplate.

  6. Este paso está sin traducir. Ayuda a traducirlo

    Remove the cover piece surrounding the Xbox button off of its pegs. Firmly hold controller and push cover piece up from the pegs. Press the Xbox button down to assist in the unclipping of the piece.
    • Remove the cover piece surrounding the Xbox button off of its pegs.

    • Firmly hold controller and push cover piece up from the pegs.

    • Press the Xbox button down to assist in the unclipping of the piece.

  7. Este paso está sin traducir. Ayuda a traducirlo

    Remove the broken bumper by unclipping it from its pegs. Hold the controller firmly and push the bumper piece up from its pegs to unclip.
    • Remove the broken bumper by unclipping it from its pegs.

    • Hold the controller firmly and push the bumper piece up from its pegs to unclip.

  8. Este paso está sin traducir. Ayuda a traducirlo

    Align the replacement bumper onto the pegs, push gently and click into place. Align the replacement bumper onto the pegs, push gently and click into place. Align the replacement bumper onto the pegs, push gently and click into place.
    • Align the replacement bumper onto the pegs, push gently and click into place.

Linea de Meta

17 personas más completaron esta guía.

2 comentarios

On my controller the screws were T8 security type, so you'll need bits with a hole in the middle

Sean H - Contestar

Is there a way to do this without removing all of the front and grip.

Alan Marantos - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 36

Ultimos 7 días: 268

Ultimos 30 días: 1,032

Todo El Tiempo: 22,233