Saltar al contenido principal
  1. You can remove the side panels with a pry tool. You don't need to remove the rubber.  The rubber on this controller was already bad
    • You can remove the side panels with a pry tool.

    • You don't need to remove the rubber. The rubber on this controller was already bad

  2. Remove the 5 Torx Security Bit (TR8) screws
    • Remove the 5 Torx Security Bit (TR8) screws

  3. Pry the panel next to the 3.5mm port Be careful to not rip the ribbon shown in the next step Be careful to not rip the ribbon shown in the next step
    • Pry the panel next to the 3.5mm port

    • Be careful to not rip the ribbon shown in the next step

  4. Kits de Reparación de Android

    A new screen or battery is one kit away.

    Comprar Ahora

    Kits de Reparación de Android

    A new screen or battery is one kit away.

    Comprar Ahora
  5. Be careful to not rip the ribbon cable You can pop the connector up to remove the ribbon easily
    • Be careful to not rip the ribbon cable

    • You can pop the connector up to remove the ribbon easily

    • Ribbon Cable

  6. Remove the 2 Torx (T6) screws
    • Remove the 2 Torx (T6) screws

  7. Desolder the 4 wires on each side, these control the vibrations and the RT LT Desolder the 4 wires on each side, these control the vibrations and the RT LT
    • Desolder the 4 wires on each side, these control the vibrations and the RT LT

  8. Pull up from the "top" side of the controller on the sister board. Pull up from the "top" side of the controller on the sister board.
    • Pull up from the "top" side of the controller on the sister board.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

EasyAsABC123

Miembro Desde 22/01/10

1,461 Reputación

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 10

Últimos 7 Días: 72

Últimos 30 Días: 266

Todo El Tiempo: 7,649