Repara tus cosas Comunidad Tienda

Xbox 360 Wireless Controller Rear Case Replacement

Introducción

Stop holding your Xbox 360 wireless controller together with duct tape. Use this guide to replace your old broken rear case.

Qué necesitas

  1. Xbox 360 Wireless Controller Rear Case Replacement, Battery: paso 1, imagen 1 de 2 Xbox 360 Wireless Controller Rear Case Replacement, Battery: paso 1, imagen 2 de 2

    • Depress the battery release button on the top of the controller.

    • Remove the battery holder from the controller.

    • The standard option for Xbox 360 Wireless Controllers Battery Packs is AA batteries. A rechargeable battery is also available, but both battery options are removed from the controller in the same way.

    Editar

  2. Xbox 360 Wireless Controller Rear Case Replacement, Rear Case: paso 2, imagen 1 de 1

    • Use a pair of tweezers to peel the barcode sticker from the battery compartment.

    Editar

  4. Xbox 360 Wireless Controller Rear Case Replacement: paso 3, imagen 1 de 1

    • Remove the seven 9.3 mm T8 Security Torx screws securing the rear case to the front case.

    Editar

  5. Xbox 360 Wireless Controller Rear Case Replacement: paso 4, imagen 1 de 2 Xbox 360 Wireless Controller Rear Case Replacement: paso 4, imagen 2 de 2
    Herramienta utilizada en este paso:
    Spudger
    $2.99
    Comprar

    • Insert a Spudger between the front and rear cases along the left edge of the controller.

    • Rotate the spudger toward the front of the controller, prying the two cases apart.

    Editar

  6. Xbox 360 Wireless Controller Rear Case Replacement: paso 5, imagen 1 de 2 Xbox 360 Wireless Controller Rear Case Replacement: paso 5, imagen 2 de 2

    • Insert a spudger between the front and rear cases, near the headphone jack.

    • Rotate the spudger toward the front of the controller to pry the two cases apart.

    Editar

  7. Xbox 360 Wireless Controller Rear Case Replacement: paso 6, imagen 1 de 2 Xbox 360 Wireless Controller Rear Case Replacement: paso 6, imagen 2 de 2

    • Grasp the controller by the battery compartment and the headphone jack.

    • Lift the battery compartment away from the headphone jack, separating the rear case from the front case and logic board.

    • The battery contact springs are held in place by slots in the battery housing in the rear case. Be sure to realign them properly during reassembly.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

22 personas más completaron esta guía.

Autor

con 6 otros colaboradores

Brett Hartt

Miembro Desde 04/12/10

127,894 Reputación

143 Guías creadas

Insignias: 52

+ 49 más insignias

Equipo

iFixit Miembro de iFixit

Staff

135 Miembros

16,767 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 11

Ultimos 30 días: 49

Todo El Tiempo: 23,260