Saltar al contenido principal

Xbox 360 CPU Heat Sink Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. Xbox 360 CPU Heat Sink Replacement, CPU Heat Sink: paso 1, imagen 1 de 2 Xbox 360 CPU Heat Sink Replacement, CPU Heat Sink: paso 1, imagen 2 de 2
    • Insert the tip of a small flathead screwdriver between the X clamp and its retaining post on the heat sink.

    • Pry the X clamp away from its retaining post until it is lifted above the small groove cut into the retaining post.

    • If necessary, insert your screwdriver parallel to the motherboard between the X clamp and its retaining post. Twist the screwdriver to fully release the X clamp from its retaining post.

    • Repeat this process for all four corners of the X clamp.

    • When removing the last corner of the X clamp and holding the motherboard upside down, be sure to catch the CPU heat sink to avoid damage from it falling.

    • Remove the CPU heat sink from the motherboard.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 1,214