Repara tus cosas Comunidad Tienda

World Dryer Airforce J4-973A3 Server Board Replacement

Introducción

If the device does not start and the Sensor Lens is in good condition, then the Circuit Board may be faulty and need replacement.

Qué necesitas

  1. World Dryer Airforce J4-973A3 Server Board Replacement, Server Board: paso 1, imagen 1 de 3 World Dryer Airforce J4-973A3 Server Board Replacement, Server Board: paso 1, imagen 2 de 3 World Dryer Airforce J4-973A3 Server Board Replacement, Server Board: paso 1, imagen 3 de 3

    • Begin by removing both screws and the brushed metal casing. Simply lift up at the indicated area with your hand.

    • The INSTALL and REMOVE indicators may be incorrect, so exercise caution when removing the screws.

    Editar

  2. World Dryer Airforce J4-973A3 Server Board Replacement: paso 2, imagen 1 de 2 World Dryer Airforce J4-973A3 Server Board Replacement: paso 2, imagen 2 de 2

    • Remove both 3/8" Ph2 screws attached to the grey belt at the top and bottom.

    • Lift the grey belt away. This gives access to the server board.

    Editar

  4. World Dryer Airforce J4-973A3 Server Board Replacement: paso 3, imagen 1 de 3 World Dryer Airforce J4-973A3 Server Board Replacement: paso 3, imagen 2 de 3 World Dryer Airforce J4-973A3 Server Board Replacement: paso 3, imagen 3 de 3

    • Remove all three 1/2" Ph1 screws connecting the server board to the device.

    • During reassembly, install the screws before reattaching the wires.

    Editar

  5. World Dryer Airforce J4-973A3 Server Board Replacement: paso 4, imagen 1 de 3 World Dryer Airforce J4-973A3 Server Board Replacement: paso 4, imagen 2 de 3 World Dryer Airforce J4-973A3 Server Board Replacement: paso 4, imagen 3 de 3

    • Use a plastic opening tool to remove the two pink capped wires in the upper left corner of the server board.

    • Use the same tool to dislodge the white capped ribbon bus with the multi-colored wires.

    • After these steps, the server board should easily come off the side of the device.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 3 otros colaboradores

Blane Hirsh

Miembro Desde 09/17/18

260 Reputación

2 Guías creadas

Insignias: 5

+ 2 más insignias

Equipo

Washington State, Team S1-G6, Hope Fall 2018 Miembro de Washington State, Team S1-G6, Hope Fall 2018

WSU-HOPE-F18S1G6

4 Miembros

4 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 2

Todo El Tiempo: 247