Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

If your blender is leaking or making strange noises, consider replacing the O-ring.

  1. Flip over the pitcher to expose the base of the blade assembly.
    • Flip over the pitcher to expose the base of the blade assembly.

    • Using the H4.0 Allen key from the 54 bit driver kit, attached to an impact driver, remove the socket head cap screw from the drive coupling.

    • Apply a solvent to remove adhesive if necessary.

  2. Using a pair of pliers, pull of the drive shaft coupling.
    • Using a pair of pliers, pull of the drive shaft coupling.

  3. ABRIR TODAS LAS PESTAÑAS

    Kits de actualización de RAM para Mac

    Compra kits

    Suficiente RAM
    para todas las pestañas

    Compra kits
  4. Using a flat head screwdriver and a mallet, bend down the two tabs holding the large nut. Using a flat head screwdriver and a mallet, bend down the two tabs holding the large nut.
    • Using a flat head screwdriver and a mallet, bend down the two tabs holding the large nut.

  5. Remove the nut using a crescent wrench.
    • Remove the nut using a crescent wrench.

  6. Push the blade assembly into the jar.
    • Push the blade assembly into the jar.

    • Remove the blades from the device.

    • Be careful not to cut yourself when handling the blades.

  7. Use tweezers to pull off the o-ring. Be careful not to cut yourself while handling the blender blades.
    • Use tweezers to pull off the o-ring.

    • Be careful not to cut yourself while handling the blender blades.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Luke Kutz

Miembro Desde 19/04/18

345 Reputación

3 Guías creadas

Equipo

Cal Poly, Team S25-G16, Maness Spring 2018 Miembro de Cal Poly, Team S25-G16, Maness Spring 2018

CPSU-MANESS-S18S25G16

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 69