Introducción
Esta guía te ayudará a sustituir los altavoces si tienes problemas de audio.
Qué necesitas
-
-
Coloca el Gamepad boca abajo y retira los dos tornillos de 4,7 mm con un destornillador Phillips de tamaño #00.
-
-
-
Con el dedo, presiona hacia abajo y tira hacia atrás de la clavija del conector de la batería.
-
Extrae la batería de su estuche.
-
-
-
-
Retira 10 tornillos de 9 mm con un destornillador Tri-Wing tamaño Y1 alrededor de la carcasa exterior.
-
Levanta la parte posterior de la caja.
-
-
-
Desenchufa con los dedos el conector exterior del motor de resonancia de la placa base.
I agree. A circle over the plug would have been better as the picture looks like you just pull on the wires lol.
Chris -
Thanks for the comment. I did get a set of tweezers and the negative cable broke anyway. They really could have done a better job at using a different connector for that.
Why in the world is this thing so tightly connected?
Thanks for the comment. I did get a set of tweezers to try to pull it out but still ended up breaking the negative cable. They really could have used a better set of cables and connectors for this.
-
-
-
Con los dedos, desenchufa el cable del altavoz izquierdo de la placa base.
Speakers are connected with solder so removing them is not possible without requiring soldering later on. I left them both connected and instead of removing the motherboard completely I just "hinged" it carefully down to facilitate the work following step 18.
Thank you for offering this info because I spent 20 minutes between scratching my head and searching for any alternatives to just the image above, which had a wire nut/housing (and mine certainly did not). As I began to have an anxiety attack (
Mine also did not have connectors for the speaker. But like mentioned above, I was able to do repair WITHOUT the need to unsolder the speaker wires. Thanks!
-
-
-
Retira el cable del altavoz derecho que está conectado a la placa base con las pinzas.
Note that on some units (presumably later ones), the speakers are soldered onto the motherboard.
-
Para volver a montar el dispositivo, sigue estas instrucciones en orden inverso.
Para volver a montar el dispositivo, sigue estas instrucciones en orden inverso.
Cancelar: No complete esta guía.
6 personas más completaron esta guía.
Un agradecimiento especial a estos traductores:
100%
¡ Carlos López (España - Spain) nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›
Un comentario
Awesome guide, replacement speakers worked flawlessly!!
tried to unscrew the 10 Tri-Wing size Y1 screw with my iFixIt toolkit
unfortunately the tool is too “fat” and short, it cannot reach 4 screws on the corners of the gamepad.
having the iFixIt toolkit and needing to purchase an additional slim screwdriver it’s a shame…
Antonello Iannone - Contestar