Saltar al contenido principal

Introducción

This guide will demonstrate how to replace the back cover of the Balance Board.

  1. Flip device upside-down so the plastic white board is facing the ground.
    • Flip device upside-down so the plastic white board is facing the ground.

    • Locate the four feet in the corners of the Balance Board.

    • Unscrew the three 12.7 mm Phillips screws from each foot cover.

  2. Remove the gray plastic ring from the actual foot by lifting it up.
    • Remove the gray plastic ring from the actual foot by lifting it up.

  3. Kits de Reparación de Android

    Estás a un kit de tu nueva pantalla o batería.

    Comprar Ahora

    Kits de Reparación de Android

    Estás a un kit de tu nueva pantalla o batería.

    Comprar Ahora
  4. Separate the loose foot from the device by lifting it up.
    • Separate the loose foot from the device by lifting it up.

  5. Repeat steps two and three on the remaining four feet.
    • Repeat steps two and three on the remaining four feet.

  6. Unscrew the ten 12.7 mm Phillips #1 screws.
    • Unscrew the ten 12.7 mm Phillips #1 screws.

  7. Lift off the gray back cover.
    • Lift off the gray back cover.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Cory Olson

Miembro Desde 29/09/14

726 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 13-8, Forte Fall 2014 Miembro de Cal Poly, Team 13-8, Forte Fall 2014

CPSU-FORTE-F14S13G8

5 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 10

Todo El Tiempo: 336