Repara tus cosas Comunidad Tienda

Wahl Chrome Pro Power Cord Replacement

Introducción

The power cord connects the clipper to a power supply. If the power cord wiring breaks due to repeated bending, the power cord may need replacement. Replacing a broken power cord makes sure the clippers receive the power needed to run the device.

Qué necesitas

  1. Wahl Chrome Pro Power Cord Replacement, Case: paso 1, imagen 1 de 1

    • Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.

    • Make sure your device is not connected to power before you begin.

    Editar

  2. Wahl Chrome Pro Power Cord Replacement: paso 2, imagen 1 de 1

    • Lift the bottom blade straight up from the device body to remove it.

    Editar

  3. Wahl Chrome Pro Power Cord Replacement: paso 3, imagen 1 de 1

    • Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.

    Editar

  4. Wahl Chrome Pro Power Cord Replacement: paso 4, imagen 1 de 1

    • Lift the base of blade assembly straight up off of the body.

    Editar

  6. Wahl Chrome Pro Power Cord Replacement: paso 5, imagen 1 de 1

    • Remove the two 12.0 mm JIS #1 screws on the back of the device body.

    Editar

  7. Wahl Chrome Pro Power Cord Replacement: paso 6, imagen 1 de 1

    • Remove the 13.0 mm Phillips #2 screw on the side of the device body.

    • This screw is located on the opposite side of the body from the switch.

    Editar

  8. Wahl Chrome Pro Power Cord Replacement: paso 7, imagen 1 de 1

    • Remove the spring on the side of the body using tweezers.

    Editar

  9. Wahl Chrome Pro Power Cord Replacement: paso 8, imagen 1 de 1

    • Pry the body case off of the device using a spudger.

    Editar

  10. Wahl Chrome Pro Power Cord Replacement, Power Cord: paso 9, imagen 1 de 2 Wahl Chrome Pro Power Cord Replacement, Power Cord: paso 9, imagen 2 de 2

    • Remove one 7.5 mm JIS #1 screw from the switch base.

    Editar

  11. Wahl Chrome Pro Power Cord Replacement: paso 10, imagen 1 de 1

    • Unplug the cord terminal from the motor connector.

    Editar

  12. Wahl Chrome Pro Power Cord Replacement: paso 11, imagen 1 de 1

    • Remove the cord from the device base by pulling gently.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 4 otros colaboradores

Manuel Salazar M.

Miembro Desde 11/07/17

101 Reputación

1 Guía escrita

Insignias: 3

Equipo

IUPUI, Team S7-G3, Baechle Fall 2017 Miembro de IUPUI, Team S7-G3, Baechle Fall 2017

IUPUI-BAECHLE-F17S7G3

3 Miembros

4 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 2

Ultimos 30 días: 7

Todo El Tiempo: 765