Saltar al contenido principal

Vtech Touch and Swipe Baby Phone Power Switch Replacement

Qué necesitas

  1. Vtech Touch and Swipe Baby Phone Power Switch Replacement, Battery: paso 1, imagen 1 de 2 Vtech Touch and Swipe Baby Phone Power Switch Replacement, Battery: paso 1, imagen 2 de 2
    • Using a Phillips #1 screwdriver, remove the 4.8mm screw on the battery cover by twisting the screwdriver counter-clockwise.

  2. Vtech Touch and Swipe Baby Phone Power Switch Replacement: paso 2, imagen 1 de 3 Vtech Touch and Swipe Baby Phone Power Switch Replacement: paso 2, imagen 2 de 3 Vtech Touch and Swipe Baby Phone Power Switch Replacement: paso 2, imagen 3 de 3
    • Remove the two AAA batteries by pulling on one end of the battery and lifting it straight out.

  3. Vtech Touch and Swipe Baby Phone Power Switch Replacement: paso 3, imagen 1 de 3 Vtech Touch and Swipe Baby Phone Power Switch Replacement: paso 3, imagen 2 de 3 Vtech Touch and Swipe Baby Phone Power Switch Replacement: paso 3, imagen 3 de 3
    • When reassembling, align the notch on the battery panel with the slot on the phone.

  4. Vtech Touch and Swipe Baby Phone Power Switch Replacement, Power Switch: paso 4, imagen 1 de 2 Vtech Touch and Swipe Baby Phone Power Switch Replacement, Power Switch: paso 4, imagen 2 de 2
    • Remove 4 13.8mm screws holding the device back using a Phillips #1 screw driver.

  5. Vtech Touch and Swipe Baby Phone Power Switch Replacement: paso 5, imagen 1 de 3 Vtech Touch and Swipe Baby Phone Power Switch Replacement: paso 5, imagen 2 de 3 Vtech Touch and Swipe Baby Phone Power Switch Replacement: paso 5, imagen 3 de 3
    • Lift directly up to remove the switch and lay the wire down to the side.

    • Once the switch has been taken out you can remove the switch's casing.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

tellocordova

Miembro Desde 09/04/15

342 Reputación

2 Guías creadas

Equipo

USF Tampa, Team 2-4, Sullivan Fall 2015 Miembro de USF Tampa, Team 2-4, Sullivan Fall 2015

USFT-SULLIVAN-F15S2G4

3 Miembros

12 Guías creadas

2 comentarios

Good work.

I have done it the same way,

the wire at the switch was bad soldered,

but it was easy to repair it and i soldered it new.

Nice.

Schwarzstein - Contestar

My baby’s phone keeps turning itself off. The switch is in the ON position but it keeps turning OFF and singing the off song. I have opened the phone and even held the switch to ON but it still keeps turning OFF even without the switch moving. Any suggestions?

shakinsher - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 3

Todo El Tiempo: 626