Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Expose the battery compartment by removing the lower back cover of the device.
-
Do this by holding the back side of the device upside down in your hands and applying pressure to the indented portion with both thumbs.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once the batteries are exposed, use your index finger to push the battery against the spring and pull up to dislodge the battery.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips #00 screwdriver, remove the two 11.2 mm Philips #00 screws located on either side of the battery slots.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert the plastic opening tool into the seam between the front and back coverings to create a gap.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unscrew the two 6.8 mm Phillips #00 screws located on the motherboard.
-
Once you've safely detached the two units, now relocate the Antenna. Flip the device and locate the solder points.
-
Using a Soldering Iron, detach the Antenna and solder a new antenna.
-