Saltar al contenido principal

Introducción

This guide provides knowledge on how to replace the Whammy bar on the 2014 Vtech Record and Learn KidiStudio.

  1. Unscrew 11 PH2 screws (7 mm). Remove black plastic backing.
    • Unscrew 11 PH2 screws (7 mm).

    • Remove black plastic backing.

    • Remove the batteries from the toy before beginning replacement of the whammy bar.

  2. Skip the upgrade.

    Descuento de $10 en tu factura de $50 con
    SKIPANDSAVE10

    Save Now

    Skip the upgrade.

    Take $10 off $50 with
    SKIPANDSAVE10

    Save Now
  3. Remove PH2 screw (5 mm) from yellow/gold colored circuit board and pull back to access the whammy component. Remove PH2 screw (5 mm) from yellow/gold colored circuit board and pull back to access the whammy component.
    • Remove PH2 screw (5 mm) from yellow/gold colored circuit board and pull back to access the whammy component.

  4. Remove 3 PH2 (5 mm) screws connected to the whammy bar component. Remove blue piece from back of the device. This will free the whammy bar. Replace the whammy bar with new part.
    • Remove 3 PH2 (5 mm) screws connected to the whammy bar component.

    • Remove blue piece from back of the device. This will free the whammy bar. Replace the whammy bar with new part.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Shaina Carbonel

Miembro Desde 01/02/16

537 Reputación

5 Guías creadas

Equipo

UW Tacoma, Team 1-1, Rose Winter 2016 Miembro de UW Tacoma, Team 1-1, Rose Winter 2016

UWT-ROSE-W16S1G1

5 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 90