Saltar al contenido principal

VTech Kidizoom Smartwatch DX2 Battery Replacement

Qué necesitas

  1. VTech Kidizoom Smartwatch DX2 Battery Replacement, Master Switch: paso 1, imagen 1 de 2 VTech Kidizoom Smartwatch DX2 Battery Replacement, Master Switch: paso 1, imagen 2 de 2
    • Begin by flipping the watch over with its back facing upwards.

  2. VTech Kidizoom Smartwatch DX2 Battery Replacement: paso 2, imagen 1 de 2 VTech Kidizoom Smartwatch DX2 Battery Replacement: paso 2, imagen 2 de 2
    • Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.

  3. VTech Kidizoom Smartwatch DX2 Battery Replacement: paso 3, imagen 1 de 2 VTech Kidizoom Smartwatch DX2 Battery Replacement: paso 3, imagen 2 de 2
    • Gently lift the backplate up to remove it.

  4. VTech Kidizoom Smartwatch DX2 Battery Replacement: paso 4, imagen 1 de 3 VTech Kidizoom Smartwatch DX2 Battery Replacement: paso 4, imagen 2 de 3 VTech Kidizoom Smartwatch DX2 Battery Replacement: paso 4, imagen 3 de 3
    • After removing the backplate, lift the master switch up from the circuit board.

  5. VTech Kidizoom Smartwatch DX2 Battery Replacement, Motherboard: paso 5, imagen 1 de 1
    • Using a Phillips #00 screwdriver, remove the 0.6 mm screw.

  6. VTech Kidizoom Smartwatch DX2 Battery Replacement: paso 6, imagen 1 de 2 VTech Kidizoom Smartwatch DX2 Battery Replacement: paso 6, imagen 2 de 2
    • Carefully remove the speaker from the case without disconnecting it from the motherboard.

  7. VTech Kidizoom Smartwatch DX2 Battery Replacement: paso 7, imagen 1 de 2 VTech Kidizoom Smartwatch DX2 Battery Replacement: paso 7, imagen 2 de 2
    • Using the tweezers, carefully lift the bar holding the connection to the screen.

    • Remove the motherboard from the device.

    and how to put it back

    noah - Contestar

    I'm trying to replace the microphone. Will replacing the motherboard get me a new microphone? I don't see it listed as a replacement part.

    Bill Pasnau - Contestar

  8. VTech Kidizoom Smartwatch DX2 Battery Replacement, Battery: paso 8, imagen 1 de 1
    • Carefully pry the battery off of the circuit board using the plastic opening tool.

    how do you swich the battery

    Nathan Snyder - Contestar

  9. VTech Kidizoom Smartwatch DX2 Battery Replacement: paso 9, imagen 1 de 1
    • De-solder the wires connecting the battery to the circuit board.

    • Remove the battery.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Jessica Richard

Miembro Desde 10/25/18

512 Reputación

4 Guías creadas

Equipo

4 comentarios

Hey guys, My VTech watch is plugged in but once I turn it on it does but then shows a dead battery. I actually didn’t play with it for a while and I left it dead battery.

Gabriel Baker - Contestar

So I might try this trick and see if it works.

Gabriel Baker - Contestar

Sometime i’ll try it

Gabriel Baker - Contestar

when I have the right tools

Gabriel Baker - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 4

Ultimos 7 días: 26

Ultimos 30 días: 125

Todo El Tiempo: 9,012