Repara tus cosas Comunidad Tienda

VTech Kidizoom Action Cam Display Assembly Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Introducción

Prerequisite Only

Qué necesitas

  1. VTech Kidizoom Action Cam Display Assembly Replacement, Display Assembly: paso 1, imagen 1 de 1

    • Make sure that the master power switch is set to the (O) position.

    Editar

  2. VTech Kidizoom Action Cam Display Assembly Replacement: paso 2, imagen 1 de 1

    • Using a plastic opening tool, gently pry off the circular plating over the camera lens.

    • The circular plating is held by a mild adhesive. It will not be necessary to replace this adhesive during the reassembly process.

    Editar

  3. VTech Kidizoom Action Cam Display Assembly Replacement: paso 3, imagen 1 de 1
    Herramienta utilizada en este paso:
    Magnetic Project Mat
    $19.95
    Comprar

    • Use a #0 screwdriver to remove the two 2.5mm Phillips head screws located on the second layer of plating.

    • Remove the second layer of plating previously held down by the screws by gripping it with your fingers and pulling upward.

    • As there will be many screws being removed from the device, we recommend using a magnetic device such as the iFixit Magnetic Project Mat.

    Editar

  5. VTech Kidizoom Action Cam Display Assembly Replacement: paso 4, imagen 1 de 1

    • Pry off the transparent plating and paper design using a plastic opening tool.

    Editar

  6. VTech Kidizoom Action Cam Display Assembly Replacement: paso 5, imagen 1 de 1

    • Unscrew the (4) 2.5mm Phillips head screws from the third layer of plating using a #0 screwdriver.

    Editar

  7. VTech Kidizoom Action Cam Display Assembly Replacement: paso 6, imagen 1 de 1

    • Turn the camera around and gently remove the plating that surrounds the LCD screen by grasping it with your fingers and pulling away from the device.

    Editar

  8. VTech Kidizoom Action Cam Display Assembly Replacement: paso 7, imagen 1 de 3 VTech Kidizoom Action Cam Display Assembly Replacement: paso 7, imagen 2 de 3 VTech Kidizoom Action Cam Display Assembly Replacement: paso 7, imagen 3 de 3

    • Use the plastic opening tool to lift the LCD screen, including the purple casing and set it aside, revealing the motherboard and connector ribbon.

    • Exercise caution while performing this step, as any excessive pulling may tear the connector ribbon from the motherboard.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 4 otros colaboradores

Anthony Teresi

Miembro Desde 02/10/16

689 Reputación

4 Guías creadas

Insignias: 19

+ 16 más insignias

Equipo

USF Tampa, Team 3-5, Sullivan Spring 2016 Miembro de USF Tampa, Team 3-5, Sullivan Spring 2016

USFT-SULLIVAN-S16S3G5

3 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 106