Saltar al contenido principal

Introducción

This guide will show you how to carefully disassemble the Unnecto Drone M with easily available tools.

  1. Place the phone facedown on a cleared work area Remove the back case by applying moderate force to the indentation in the lower left corner of the case.
    • Place the phone facedown on a cleared work area

    • Remove the back case by applying moderate force to the indentation in the lower left corner of the case.

  2. Grip the top right corner of the battery.
    • Grip the top right corner of the battery.

    • Remove the battery by pulling it outwards.

  3. Remove the four screws on the back of the phone using a Philips 000 screwdriver
    • Remove the four screws on the back of the phone using a Philips 000 screwdriver

  4. Baterías para ordenadores portátiles

    Un pequeño arreglo para un gran resultado.

    Comprar Ahora

    Baterías para ordenadores portátiles

    Un pequeño arreglo para un gran resultado.

    Comprar Ahora
  5. Separate the frame evenly using a plastic opening tool.
    • Separate the frame evenly using a plastic opening tool.

    • Be careful, as the frame is thin and can break easily.

  6. Use a Phillips #000 screwdriver to remove the four screws that secure the motherboard. Use a Phillips #000 screwdriver to remove the four screws that secure the motherboard.
    • Use a Phillips #000 screwdriver to remove the four screws that secure the motherboard.

  7. Disconnect the ribbon cable from the motherboard using rounded, spade-tipped tweezers.
    • Disconnect the ribbon cable from the motherboard using rounded, spade-tipped tweezers.

  8. Peel the white circuit on left side of the frame by inserting fine-tipped tweezers between it and the frame.
    • Peel the white circuit on left side of the frame by inserting fine-tipped tweezers between it and the frame.

    • The white circuit is flimsy and securely glued to the frame.

  9. Set aside the circuit board from the screen protector. Set aside the circuit board from the screen protector.
    • Set aside the circuit board from the screen protector.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 35