Peligro
Potencialmente Peligroso
Una lesión puede resultar si este procedimiento no se sigue correctamente. Ten precaución y sigue todas las advertencias.
Peligro

Introducción

In order to have a safer biking experience, make sure your disk brake is properly replaced.

Partes

No se requieren partes.

  1. Begin loosening the tire by turning the quick release handle.
    • Begin loosening the tire by turning the quick release handle.

  2. Gripping the rear derailleur, pull the arm back, away from the front of the bike. Notice how the derailleur becomes almost vertical in the second picture when compared to the first.
    • Gripping the rear derailleur, pull the arm back, away from the front of the bike.

    • Notice how the derailleur becomes almost vertical in the second picture when compared to the first.

  3. ¡Envío gratuito para todos los pedidos de más de USD100.00 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda
  4. There should be enough slack, in the chain, at this point to remove the tire from the bike. Note: You may need to wiggle the tire and chain around in order to create enough slack.
    • There should be enough slack, in the chain, at this point to remove the tire from the bike.

    • Note: You may need to wiggle the tire and chain around in order to create enough slack.

    • Remove the tire from the bike.

  5. Place the tire  flat on the ground making sure the disk is facing you.
    • Place the tire flat on the ground making sure the disk is facing you.

  6. Using the modular screw driver with a T25 bit, begin loosening and then removing the six 10mm-long screws. Make sure to keep track of all of the removed pieces. Make sure to keep track of all of the removed pieces.
    • Using the modular screw driver with a T25 bit, begin loosening and then removing the six 10mm-long screws.

    • Make sure to keep track of all of the removed pieces.

  7. After all of the screws have been removed, take the disk and pull it away from the tire. After all of the screws have been removed, take the disk and pull it away from the tire.
    • After all of the screws have been removed, take the disk and pull it away from the tire.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Daniel

Miembro Desde 27/01/14

222 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 1-37, Maness Winter 2014 Miembro de Cal Poly, Team 1-37, Maness Winter 2014

CPSU-MANESS-W14S1G37

4 Miembros

6 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 331