Repara tus cosas Comunidad Tienda

Trek 820 Light Mount Replacement

Introducción

You may need to replace the light mount on your bicycle because the light has burned out or you require a brighter light. This guide shows the proper steps to install a replacement Light Mount for a Trek 820 (or similar) bicycle. No tools are necessary for this easy repair.

Qué necesitas

  1. Trek 820 Light Mount Replacement, Light Mount: paso 1, imagen 1 de 2 Trek 820 Light Mount Replacement, Light Mount: paso 1, imagen 2 de 2

    • Clean the area where the light mount will be installed with a soft cloth.

    • Placing the light mount close to the center stem.

    Editar

  2. Trek 820 Light Mount Replacement: paso 2, imagen 1 de 1

    • Remove the strap from the light mount fitting.

    • Stretch the strap clockwise around the handlebars.

    Editar

  4. Trek 820 Light Mount Replacement: paso 3, imagen 1 de 1

    • Slide the strap through the slot and fasten to a snug, but moveable fit.

    • Do not fasten too tight as this will make it difficult to fine tune light mount placement.

    Editar

  5. Trek 820 Light Mount Replacement: paso 4, imagen 1 de 1

    • Pull the strap tightly through the clasps at the bottom of the mount.

    Editar

  6. Trek 820 Light Mount Replacement: paso 5, imagen 1 de 2 Trek 820 Light Mount Replacement: paso 5, imagen 2 de 2

    • Place the fastening screw in the rear screw port on the light mount.

    • Twist the screw clockwise using your hands until fully fastened.

    Editar
Conclusión

Now you have a light mount ready for safer night rides on your Trek bicycle!

Autor

con 6 otros colaboradores

Kaveh Karimiyanha

Miembro Desde 09/24/12

813 Reputación

7 Guías creadas

Insignias: 10

+ 7 más insignias

Equipo

Cal Poly, Team 1-1, Propen Fall 2012 Miembro de Cal Poly, Team 1-1, Propen Fall 2012

CPSU-PROPEN-F12S1G1

5 Miembros

9 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 843