Introducción

The optical drive is what reads a CD or DVD when placed in the drive. To replace it, follow the steps outlined in this guide.

Partes

No se requieren partes.

  1. Unlock the right tab by sliding it to the right with your finger.
    • Unlock the right tab by sliding it to the right with your finger.

    Agregar Comentario

  2. Hold the left tab to the left using your left hand.
    • Hold the left tab to the left using your left hand.

    Agregar Comentario

    • Remove the battery by placing your finger in the middle groove and lifting up.

    Agregar Comentario

    • Remove the 13 Phillips #1 10mm screws from the backside of your computer using a Phillips #1 screwdriver.

    Agregar Comentario

    • Remove the two Phillips #1 6mm screws from the backside of your computer using a Phillips #1 screwdriver.

    Agregar Comentario

    • Remove the three 3mm screws from beneath the battery with a Phillips #1 screwdriver.

    Agregar Comentario

    • Lift up the corner panel and remove it with your hand.

    Agregar Comentario

    • Unscrew the four Phillips #1 3mm using a Phillips #1 screwdriver.

    • Unscrew the four 10mm screws around hard drive using a Phillips #1 screwdriver.

    Agregar Comentario

    • To remove the hard drive case, first pull the black tab to the right.

    • Then pull the black tab up to remove the case.

    Agregar Comentario

    • Remove the plastic strip above the "F" keys using the spudger by placing the small end of the spudger under the strip and lifting up.

    Agregar Comentario

    • Remove the two Phillips #1 3mm screws underneath the plastic strip using a Phillips #1 screwdriver.

    Agregar Comentario

    • Lift the keyboard up and remove it with your hands.

    Agregar Comentario

    • Remove the five Phillips #1 10mm screws underneath the keyboard using a Phillips #1 screwdriver.

    Agregar Comentario

    • Lift up the plastic panel and carefully disconnect the red and white ports.

    • Remove the panel

    Agregar Comentario

    • Turn the laptop over so the bottom is facing up

    • Then remove the 3mm screw with a #1 screwdriver, located underneath the panel containing the wifi card and RAM

    Agregar Comentario

    • Turn the laptop back over so the motherboard is facing up

    • Now slide the optical drive out of the computer by gently pulling it to the right

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

NateJohnson

Miembro Desde 26/01/14

985 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 9-26, Maness Winter 2014 Miembro de Cal Poly, Team 9-26, Maness Winter 2014

CPSU-MANESS-W14S9G26

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 4

Últimos 30 Días: 10

Todo El Tiempo: 851