Toshiba Satellite L305D-S5950 Fan Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

In order to replace the fan in your device the hard drive, keyboard, motherboard cover, and the motherboard need to be removed.

The hard drive needs to be removed since it is connected to the motherboard through a hole bottom section of the motherboard case.

The keyboard needs to be removed due to the cable connecting it to the motherboard interfering with the removal of the top part of the motherboard case.

Qué necesitas

Paso 1 Battery

Toshiba Satellite L305D-S5950 Fan Replacement, Battery: paso 1, imagen 1 de 1

Locate the two sliding battery locks on the underside of the laptop.

Traducir

Paso 2

Locate the right battery lock and slide it to the right.

Traducir

Paso 3

While holding the left battery lock to the left, lift up the battery using the tab located on the top center of the battery.

Traducir

Paso 4

Remove the battery from the laptop.

Traducir

Paso 5 Hard Disk Drive

Toshiba Satellite L305D-S5950 Fan Replacement, Hard Disk Drive: paso 5, imagen 1 de 2

Toshiba Satellite L305D-S5950 Fan Replacement, Hard Disk Drive: paso 5, imagen 2 de 2

Unscrew the screws enough to remove the top cover.

Traducir

Paso 6

Remove the cover by lifting the right side up at an angle before removing the entire cover.

Traducir

Paso 7

Remove the hard drive from the SATA slot by tugging lightly on the ribbon cable to the right.

Traducir

Paso 8

Toshiba Satellite L305D-S5950 Fan Replacement: paso 8, imagen 3 de 3

To separate the hard drive from the caddy, unscrew the two screws.

Traducir

Paso 9 RAM

Toshiba Satellite L305D-S5950 Fan Replacement, RAM: paso 9, imagen 1 de 3

Toshiba Satellite L305D-S5950 Fan Replacement, RAM: paso 9, imagen 2 de 3

Toshiba Satellite L305D-S5950 Fan Replacement, RAM: paso 9, imagen 3 de 3

Unscrew the RAM cover and rotate the cover up to remove it. The screw should not be fully removed from the cover itself.

Traducir

Paso 10

Push the small levers at the sides of the RAM module away from each other. The RAM module should automatically rotate upwards.

Traducir

Paso 11

Remove the RAM module by pulling it out at the angle it was rotated to.

Traducir

Paso 12

Toshiba Satellite L305D-S5950 Fan Replacement: paso 12, imagen 3 de 3

If you want to replace the second RAM module, apply steps 2 and 3 to do so.

Traducir

Paso 13 Keyboard

Toshiba Satellite L305D-S5950 Fan Replacement, Keyboard: paso 13, imagen 1 de 2

Toshiba Satellite L305D-S5950 Fan Replacement, Keyboard: paso 13, imagen 2 de 2

Locate the plastic strip at the top of the keyboard.
Use a pry tool to remove the plastic strip.
Using your hands pull out the rest of the plastic strip.

Traducir

Paso 14

Use a phillips head #0 screwdriver to remove the two 3.75mm screws holding the keyboard in place.

Traducir

Paso 15

Toshiba Satellite L305D-S5950 Fan Replacement: paso 15, imagen 3 de 3

Lift up the top of the keyboard to remove it.
Under the keyboard there is a ribbon cable connecting the keyboard to the laptop. Do not just quickly pull out the keyboard.
Unlock the ribbon cable by pushing on the locks that are located on both sides of ribbon cable.
Unplug the ribbon cable from the laptop.

Traducir

Paso 16

Remove the keyboard completely from the laptop.

Traducir

Paso 17 Motherboard Cover

Toshiba Satellite L305D-S5950 Fan Replacement, Motherboard Cover: paso 17, imagen 1 de 2

Toshiba Satellite L305D-S5950 Fan Replacement, Motherboard Cover: paso 17, imagen 2 de 2

Remove all 6.75mm screws from the bottom of the laptop. The 3 screws under the battery are 3.75mm.
Remove all 5.25mm screws from the top of the laptop.

Traducir

Paso 18

Toshiba Satellite L305D-S5950 Fan Replacement: paso 18, imagen 3 de 3

Unplug the wires highlighted with red squares.
Using a pry tool and yours hands to remove the motherboard cover.

Traducir

Paso 19 Motherboard

Toshiba Satellite L305D-S5950 Fan Replacement, Motherboard: paso 19, imagen 1 de 1

Unscrew all the screws indicated by the red circles (The bottom two screws are 10.75mm and the top screw is 5mm).
Unplug all the wires indicated by the orange squares.
Some wires may have a lock on them that needs to be pulled out before the wire is removed.