Introducción
Use this guide to remove or install a motherboard on your Toshiba Satellite L305-S5946. It will be necessary to remove the motherboard to replace the GPU. This guide also acts as a prerequisite for the processor and cooling fan installation guides.
Qué necesitas
-
-
Loosen the two captive screws on the bottom left corner of the hard drive using a Phillips #1 screwdriver until you hear a click.
-
-
-
Using a Phillips #1 screwdriver, turn the screw on the RAM cover until you hear a click.
-
-
-
-
Place the laptop upside-down with the display hinges facing away from you.
-
-
-
For the following steps, use a Phillips #1 screwdriver.
-
Remove the twelve 6-mm screws that border the bottom of the laptop.
-
Remove the 6-mm screw located in the lower middle of the device.
-
Remove the three 3-mm screws located in the battery bay.
-
Remove the one 4-mm screw located near the RAM.
-
-
-
Use a Phillips #1 screwdriver to remove the four 6-mm screws from the two hinge pads that secure the display assembly to the lower laptop section.
-
-
-
Use tweezers to remove the following two connectors:
-
One of the connectors has one black and one white wire.
-
The other connector has black, green, red, yellow, and white wires.
-
Use your fingers to remove the following connector:
-
The connector is large and is located at the top right corner of the motherboard, as shown.
-
-
-
Remove the power jack connector.
-
Remove the connector that has one red wire and one black wire.
-
Remove the connector with red, yellow, green, white, and black wires.
-
Remove the large connector near the fan.
-
Gently pull the power jack cable and socket out of its housing. It should come out entirely.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.