Saltar al contenido principal

Partes

No se especificaron partes.

  1. TomTom XXL 540 Battery Replacement, Battery: paso 1, imagen 1 de 1
    • Peel back the sticker on the bottom of the device to reveal the two screws.

  2. TomTom XXL 540 Battery Replacement: paso 2, imagen 1 de 1
    • Unscrew the two T5 Torx screws.

  3. TomTom XXL 540 Battery Replacement: paso 3, imagen 1 de 1
    • Wedge the flat head of the screwdriver into the edge of the device. Gently lift the screen from the cover.

  4. TomTom XXL 540 Battery Replacement: paso 4, imagen 1 de 1
    • Release the yellow ribbon cable.

  5. TomTom XXL 540 Battery Replacement: paso 5, imagen 1 de 1
    • Identify the green motherboard. Unscrew the three screws holding the board in place.

  6. TomTom XXL 540 Battery Replacement: paso 6, imagen 1 de 1
    • Remove the motherboard from the back plate.

  7. TomTom XXL 540 Battery Replacement: paso 7, imagen 1 de 1
    • Unplug the battery from the board.

  8. TomTom XXL 540 Battery Replacement: paso 8, imagen 1 de 1
    • Plug the new battery into the white receptacle on the green motherboard.

  9. TomTom XXL 540 Battery Replacement: paso 9, imagen 1 de 1
    • Transfer the green motherboard back into the back plate and secure it with the 3 screws.

  10. TomTom XXL 540 Battery Replacement: paso 10, imagen 1 de 1
    • Reconnect the yellow ribbon cable and connect the screen and back plate back together.

  11. TomTom XXL 540 Battery Replacement: paso 11, imagen 1 de 1
    • Insert the t-5 screws and tighten to secure.

  12. TomTom XXL 540 Battery Replacement: paso 12, imagen 1 de 1
    • Replace the label to cover the screws.

Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

Mike Sollars

Miembro Desde 11/07/13

507 Reputación

3 Guías creadas

Equipo

WRI115, Team 1-1, Ruszkiewicz Spring 2013 Miembro de WRI115, Team 1-1, Ruszkiewicz Spring 2013

WRI115-RUSZKIEWICZ-S13S1G1

4 Miembros

6 Guías creadas

Un Comentario

Very similar for the 4FL60 and 6000, except in :

Step 1 the screws are visible without removing any stickers

Step 4 hint: to release the ribbon, each end of the white bar has a self-sprung clip to ease away, try not to break them. And for the models above there is a small cable plug to unclip

Step 5 there are 5 screws holding the motherboard

Step 6 it is necessary to unclip plugs for the battery and speaker leads

and vice versa for reassembly

Jim Shaw - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 15

Ultimos 30 días: 28

Todo El Tiempo: 4,225