Introducción

Batteries do not last forever, so this guide is to show you how to replace the battery.

  1. Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.
    • Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.

    Agregar Comentario

  2. Using a spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.
    • Using a spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.

    Agregar Comentario

    • Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device.

    Agregar Comentario

    • Once the two covers are separated, use the tweezers, or even your fingers, to gently disconnect the two sets of wires that are connected to the motherboard from the back cover. You may have to wiggle the wires a little bit to get them to disconnect.

    Agregar Comentario

    • Using the spudger, gently pry out the battery.

    • The battery may seem tough to get out due to the adhesive used to secure it. Just slowly work at it and do not force anything.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Trevor Foster

Miembro Desde 18/04/10

142 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 7-7, Maness Spring 2010 Miembro de Cal Poly, Team 7-7, Maness Spring 2010

CPSU-MANESS-S10S7G7

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 6

Últimos 30 Días: 27

Todo El Tiempo: 9,399