Partes

No se requieren partes.

Power down the TiVo and detach the power cable from the rear of the unit.
  • Power down the TiVo and detach the power cable from the rear of the unit.

    • Wait 5 minutes for the unit to fully discharge before proceeding to the next step.

Agregar Comentario

Remove the five T10 screws from the rear of the case using the Torx screwdriver.
  • Remove the five T10 screws from the rear of the case using the Torx screwdriver.

Agregar Comentario

  • Lift up and pull back the outer casing towards the rear of the unit.

I have the TiVo Series 2 model TCD746500 and the procedure for replacing a fan on my model is almost identical to the procedure described here, with one significant difference at this step: first pull/slide the outer casing back towards yourself and only thereafter pull it up.

Oscar Abraham Jaeger - Contestar

  • The fan is held in by four T15 screws on the rear of the device.

Agregar Comentario

  • Take the wound red and black wires coming from the fan and follow them back to the logic board.

  • Unplug the connector from the motherboard.

Agregar Comentario

  • Pull the fan towards the front and out of the TiVo unit.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

Cal Poly, Team 33-79, Johann Spring 2010 Miembro de Cal Poly, Team 33-79, Johann Spring 2010

CPSU-JOHANN-S10S33G79

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 2

Todo El Tiempo: 5,048