Saltar al contenido principal

Introducción

Unfortunately, my iFixit kit has not yet arrived, so I had to use my Wiha drivers and generic spudger. This is pretty simple to do!

Partes

No se especificaron partes.

  1. Remove the nine Phillips screws using a Philips 00 screwdriver Remove the nine Phillips screws using a Philips 00 screwdriver Remove the nine Phillips screws using a Philips 00 screwdriver
    • Remove the nine Phillips screws using a Philips 00 screwdriver

  2. Pry up the case carefully using a spudger. Make sure to not push the spudger in too far, as this could result in internal damage
    • Pry up the case carefully using a spudger.

    • Make sure to not push the spudger in too far, as this could result in internal damage

  3. Lift off the cover, and you're done!
    • Lift off the cover, and you're done!

Conclusión

To reassemble, place the bottom cover on and push until you hear a satisfying click. Keep doing this until the whole cover is secured. Then, screw all of the screws back in!

2 personas más completaron esta guía.

Tanner Lange

Miembro Desde 18/03/18

981 Reputación

3 Guías creadas

Equipo

Francophones Miembro de Francophones

Community

8 Miembros

8 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 10

Últimos 30 Días: 39

Todo El Tiempo: 566