Saltar al contenido principal

Introducción

The boiler heat the water to the needed temperature for both the steam wand and portafilter. If your machine isn't heating up, one possible cause is a failed heating element inside the boiler. This guide will show you how to test for this.

Partes

No se especificaron partes.

  1. Remove the 6 Phillips #1 screws from the back panel. Remove the back panel.
    • Remove the 6 Phillips #1 screws from the back panel.

    • Remove the back panel.

  2. Make sure the machine is turned off and unplugged.
    • Make sure the machine is turned off and unplugged.

    • Set your voltmeter in continuity mode and place the leads on the two 90 degree prongs on the boiler's heating element.

    • It does not matter which lead touches which prong as you're just testing for a break, or "open" in the heating element circuit.'''

    • If the voltmeter shows 0, or "open", then there is an issue with the heating element's continuity and it needs to be replaced.

    • If given a reading, then your heating element is fine.

  3. In the water reservoir, place mixture of de-calcifying agent and water as directed on the product label.
    • In the water reservoir, place mixture of de-calcifying agent and water as directed on the product label.

    • Place a cup, to catch fluid, underneath the portafilter.

    • Run Barista, as if making coffee, for the amount of time directed by the de-calcifying product.

    • See the links section of the device page for further directions.

Conclusión

To reassemble your device, follow these instructions in reverse order.

8 personas más completaron esta guía.

Brian McMurray

Miembro Desde 31/01/11

198 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 4-42, Regan Winter 2011 Miembro de Cal Poly, Team 4-42, Regan Winter 2011

CPSU-REGAN-W11S4G42

4 Miembros

5 Guías creadas

I did this a few months ago and the boiler was full of rusty gunk. This guide sure did help me out.

oguitar200 - Contestar

the same here - it was disgusting... was afraid to have damaged it while cleaning it. tested it yesterday already... just going through all the steps to validate function of the units.

Martin Zeitler -

hi ! we have Starbucks Barisa Milano. some how it didnt want switch on! my husband wanted to have a look but we cant open. do you gave any guidence?

Zorigoo Purev - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 3

Últimos 30 Días: 52

Todo El Tiempo: 17,541