Repara tus cosas Comunidad Tienda

Teenage Engineering OP-Z Back Cover Replacement

Introducción

Use this guide to open the OP-Z and replace the back cover.

  1. Teenage Engineering OP-Z Back Cover Replacement, Back Cover: paso 1, imagen 1 de 3 Teenage Engineering OP-Z Back Cover Replacement, Back Cover: paso 1, imagen 2 de 3 Teenage Engineering OP-Z Back Cover Replacement, Back Cover: paso 1, imagen 3 de 3

    • Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.

    • There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.

    Editar

  3. Teenage Engineering OP-Z Back Cover Replacement: paso 2, imagen 1 de 2 Teenage Engineering OP-Z Back Cover Replacement: paso 2, imagen 2 de 2

    • When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).

    • If the bottom plate won’t come off you might want to make sure every foot is rotated correctly and gently tug on one of them.

    Editar

  4. Teenage Engineering OP-Z Back Cover Replacement: paso 3, imagen 1 de 1

    • Remove the bottom plate including the rubber feet.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 1 otro colaborador

Tobias Isakeit

Miembro Desde 03/31/14

117,296 Reputación

188 Guías creadas

Insignias: 46

+ 43 más insignias

Equipo

Master Techs Miembro de Master Techs

Community

322 Miembros

2,521 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 3

Ultimos 30 días: 15

Todo El Tiempo: 1,496